Forum: Jetboats

Hi - finally have found the details of the boat, thanks to great members of this forum. Underneath the landing Ski board, it is engraved into...

I was out on the water this week end and on averaging 35 mph, when suddenly and without warning, my craft lost power. Maybe I'm out of gas? No. ...

I just have a question about oil leaking out of the back of my ski. Today I took the jugs off and one of the pistons is shot. The question I have...

I am in need of a 1997 Challenger 1800 Accessories Cover because my repair shop forgot to put mine back on the boat when they worked on it. Now they...

I just took out my 1996 Polaris XLT 780 and discovered that there was fuel coming out of the one of the Mikuni carb cover(all three covers have a...

I just have a question about overspeeding when I advance the throttle to full open position the boat doesn't speed up but it sounds like the jet...

I just purchase a jet boat and I am wondering where I can get a maintenance manual. Because on the bottom of the boat is a blue box and I would like...

Steve do we know how long the yamaha jet boat board will be out of service?? it's driving me nuts ,, ok so I'm already nuts but it's making me...

I am trying to take the starters out of my 1998 Yamaha Exciter 1100. I have removed the 2 bolts from the back of the starter and it will not budge at...

hey guys well i came on here a while back and had the same issue that my seadoo challenger 1 engine will not go faster then 5 miles and i am reving...

I did play with that ider a while back but the stress would most likely be too great for the 2 pivot bolts on the existing boat pumps

Here is a picture of what you need to get in to the broken threads.

Just for illustration purposes I made a quick pic to show what the mod would look like using some old items I had laying around. Obviously I didn't...

Einladung: zur 2. Jetski Trekking-Tour Berlin – Brandenburg 2007 Die zweite Jetski Trekking Tour startet in Klein Köris (Brandenburg) nach und...

the board is down because the hosting company turned it off due to someone hacking it and causing problems with other sites. * The problem is being...

I was taking a few pictures of some steering units being born in the cobra jet cave, where I am chained to the wall and forced to do slave labor.

Every once in a while I run in to a challenge making steering mods for jet boats. Sea Doo has a bad habit of changing their engine and pump setups,...

When working on marine engines you will eventually snap off a bolt, usually it's a stainless bolt going through aluminum like a head bolt. I...

Most coils for skies have the plug wires molded or glued in the coil, there is a pin or a screw that the wire is attached to, they seal the wire and...

new waterproof sticker